GC Fuji 2 LC Capsules 1cap

Radiopaque Light-Cured Reinforced Glass Ionomer Restorative in Capsule
The first light-cured glass ionomer filling restorative in capsule enhances properties of genuine glass ionomers in strength, aesthetics and handling.
Featuers:-
• Smaller particles offers excellent aesthetics and polishability
• High filler loading for significantly improved abrasion resistance
• Strontium based glass provides good radiopacity facilitating post-operative diagnosis
• Optimal adhesion to tooth structure when used in combination with GC Cavity Conditioner or GC Dentine Conditioner allowing minimal cavity preparation
• Triple cure mechanism allows for immediate finishing after light curing while ensuring total material set
• High fluoride release protects against secondary caries
• Available in VITA* shades to create natural shade match
• Faster, easier and more efficient placement
• No measuring as powder and liquid are pre-measured in the right ratio
• Mechanical mixing leads to less porosities and a stronger cement
* VITA? is a registered trademark of Vita?-Zahnfabrik Bad Sackingen, Germany
Key Specification :-
•  Smaller particles – offers excellent aesthetics
•  Strontium based glass provides good radiopacity
•  High fluoride release
•  Faster, easier and more efficient placement
Indication:-
• Class III and V restorations
• Root surface caries and cervical erosion
• Abfraction lesions
• Lesions where cavity margins are in dentine or when enamel prisms cannot be properly etched
Directon:-
• After conditioning the tooth surface with GC Cavity Conditioner (20% polyacrylic acid), apply the Gold Label 2LC or Fuji II LC Capsule mixed accordingly into the cavity.
• Form the contour and place a matrix if required during the working time.
• Light cure for 20 seconds.
• Final finishing under water spray can be carried out immediately after light curing.
• After finishing, apply a final coat of GC Fuji Coat LC as a protective coating. Alternatively, application of a final protective coat of G-Coat PLUS can improve wear resistance.
Tech Info :-
• Mixing Time (sec) 10?
• Working Time (min, sec) 3?45?
• Finishing begins (from start of mix) 20?
* Mixing conditions at 23?C. Higher temperatures will shorten working time.